TECNICAL CHARACTERISTICS

Osmotized water

Autwomatic RO Process produces from 20 to 120 l/h Type III water from tap water.

Based on a sequential purification steps :sediment filtration, dechlorination, reverse osmosis, and optionally Ultraviolet treatment and final filtration of 0.22 micron.

Ideal to supply water to industrial processes and machines requiring purified water with the lower cost per liter.

Automatic operation

The equipment starts and stops automatically, thus guarantying the production of Osmotized  Water.
Automatic stop in case of water supply cut. 

Parameters customizing

The user can fix different parameter values, according to the control requirements:

- Pre-treatment time
- Minimum performance of the reverse osmosis module.

Warnings

The equipment warns, by a visual and audio message, of the need to replace the consumables, according to the fixed values.

-  Pre-treatment change
-  Interchange resin change
-  Warning of malfunction of conductivity and temperature probes

The equipment warns by a visual ans audio message of the need to replace consumables, according to the fixed values.

Pretreatment reinforcement

In case of feed water containing high levels of solids or high hardness, it is convinient to reinforce the Standard pretreatment with:

-  Mineral Filter , automatic, with autocleaning device.
- Softener: Reduces water hardness, increasing the live of equipment.

Ultraviolet lamp

The disinfection equipment emits ultraviolet radiation in two wave lengths, leading to a reduction of the bacterial content of 5 logaritmic cycles. This provides the user with water with minimum bacterial contamination if needed and produces the oxidation of organic material traces in the water.

Open tank and Pressurized tank

The equipment can be supplied with an pressurized tank where water is stored avoiding the contact with air or Light.

When high storage volume are necessary, open tanks are supplied, with electrical level detection and overflow.

Conductimeter calibration and system verification

Autwomatic software allows the adjustment and calibration of the conductivity meter by a traceable certified standard, according to the national standards of the German Deutscher Kalibrierdienst (DKD).

Wasserlab’s Technical Assistance Service offers, at user request:

1. Periodic equipment calibration service.
2. Complete system verification, with the extension of the relevant certificate.